2016 Kia K900 V8FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Remove the engine room LH side cover (A).
    Fig 1: Removing Engine Room LH Side Cover
    G11802853Courtesy of KIA MOTORS AMERICA, INC.
  3. Disconnect the IDB connector (A).
    Fig 2: Disconnecting IDB Connector
    G11802854Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the harness installation nut (A) and ground bolt (B), and then remove the harness (C).
    Fig 3: Removing Harness Installation Nut And Ground Bolt
    G11802855Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the ECM connector (A) and the TCM connector (B).
  6. Remove the ECM & TCM bracket mounting bolts (C) and nut (D).
    Fig 4: Removing ECM & TCM Bracket Mounting Bolts And Nut
    G11802856Courtesy of KIA MOTORS AMERICA, INC.
  7. After removing the mounting bolts (A), remove the TCM bracket assembly (B).
    Fig 5: Removing TCM Bracket Assembly
    G11802857Courtesy of KIA MOTORS AMERICA, INC.
  8. After removing the mounting nuts (A), remove the ECM (B) from the bracket
    Fig 6: Removing ECM From Bracket
    G11802858Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.