2016 Kia K900 V6FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

[Knock Sensor #1 (Bank 1)]

  1. Turn the Ignition Switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the knock sensor connector (A).
    Fig 1: Locating Knock Sensor Connector (Knock Sensor 1 - Bank 1)
    G11804967Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the mounting bolt (A), and then remove the sensor from the cylinder block.
Fig 2: Locating Knock Sensor Mounting Bolt
G11804968Courtesy of KIA MOTORS AMERICA, INC.

[Knock Sensor #2 (Bank 2)] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the knock sensor connector (A).
    Fig 3: Locating Knock Sensor Connector (Knock Sensor 2 - Bank 2)
    G11804969Courtesy of KIA MOTORS AMERICA, INC.
  3. Drain the coolant (Refer to Engine Mechanical System - "COOLANT ").
  4. Remove the alternator (Refer to Engine Electrical System - "ALTERNATOR ")
  5. Remove the mounting bolt (A), and then remove the sensor from the cylinder block.
Fig 4: Locating Knock Sensor Mounting Bolt
G11804970Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.