2016 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install in the reverse order of removal.
    NOTE: The existing valve body cover gasket (A) must be replaced with a new one. (Do not reuse it.)
    Fig 1: Remove/Install Valve Body Cover Gasket
    G11797223Courtesy of KIA MOTORS AMERICA, INC.
  2. Perform the procedures below after installing.
    1. Refill the automatic transaxle with fluid.

      (Refer to Hydraulic System - "Automatic Transaxle Fluid ")

    2. Clear the diagnostic trouble codes (DTC) using the KDS/GDS. Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS/GDS at all times.
    3. Reset the automatic transaxle adaptive values using the KDS/GDS.
      Fig 2: GDS Screen Display - Resetting Auto T/A Values
      G11797224Courtesy of KIA MOTORS AMERICA, INC.
    4. Perform the TCM adaptive values learning procedure.

      (Refer to Automatic Transaxle Control System - "ADJUSTMENTΒ ")

    5. After installing, check for leakage of coolant or fluid from hose connection during engine start.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.