2016 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Place the shift lever into the "N" position.
  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and the battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Disconnect the inhibitor switch connector (A).
    Fig 1: Locate Inhibitor Switch Connector
    G11797269Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the shift cable mounting nut (A).
    Fig 2: Locate Shift Cable Mounting Nut
    G11797270Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the manual control lever (B) and the washer after removing a nut (A).
    Fig 3: Locate Manual Control Lever
    G11797271Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the inhibitor switch (A) after removing the bolts (2ea).
Fig 4: Locate Inhibitor Switch Installation Position
G11797272Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.