2016 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

AVN Head Unit

WARNING: This page is about a different car, the 2015 Kia Forte5, 2015 Kia Forte Koup, and 2015 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Take care not to scratch the center fascia panel and related parts.
  • Eject all the disc before removing the AVN head unit to prevent damaging the CD player's load mechanism.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the center fascia panel.

    (Refer to "CENTER FASCIA PANEL ")

  3. Remove the cluster fascia panel.

    (Refer to "CLUSTER FASCIA PANEL ")

  4. Remove the driver air vent duct assembly (A) after loosening the mounting screws.
    Fig 1: Driver Air Vent Duct Assembly And Screws
    G09744772Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the clock fascia panel (A) after loosening the mounting screws.
    Fig 2: Clock Fascia Panel And Mounting Screws
    G09744773Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the clock connector (A).
    Fig 3: Clock Connector
    G09744774Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the center air vent duct assembly [RH] (A) after loosening the mounting screws.
    Fig 4: Center Air Vent Duct Assembly (RH)
    G09744775Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the AVN head unit (A) after loosening the mounting.
    Fig 5: AVN Head Unit
    G09744776Courtesy of KIA MOTORS AMERICA, INC.
  9. Remove the AVN head unit connectors and cables (A).
    Fig 6: AVN Head Unit Connectors And Cables
    G09744777Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.