Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Passenger Power Window Switch Inspection

Disconnect the negative (-) battery terminal.
Remove the front door trim panel.
(Refer to Body - "FRONT DOOR TRIM ")
Disconnect the connector from the switch.

Fig 1: Disconnect Passenger Power Window Switch Connector From Switch
Courtesy of KIA MOTORS AMERICA, INC.
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[Auto]

Fig 2: Passenger Power Window Switch Continuity Reference Chart (Auto)
Courtesy of KIA MOTORS AMERICA, INC.

[Manual]

Fig 3: Passenger Power Window Switch Continuity Reference Chart (Manual)
Courtesy of KIA MOTORS AMERICA, INC.
Remove the power window switch(A) after loosening the screws.

Fig 4: Remove Power Window Switch

Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.