2016 Kia Cadenza BaseFACTORY OEM SERVICE PROCEDURE

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible cause
DTC Strategy
  • Power voltage of fuel pressure sensor monitoring
  1. Poor Connection
  2. Open or short in power circuit
  3. Fuel pump control module (FPCM)
Enable Conditions
  • Engine "ON"
  • Battery Voltage is higher than 10V
  • Target fuel pressure is higher than 350kpa and lower than 600kpa.
Threshold value
  • Power voltage of fuel pressure < 4.5V
Diagnosis Time
  • 2 sec.
MIL On Condition
  • -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.