Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - 1.6LETC (ELECTRONIC THROTTLE CONTROL) SYSTEMREPAIR PROCEDURESADJUSTMENT
2015 Kia Soul Base, Standard Trans
Repair Procedures: Adjustment
2015 Kia Soul Base, Standard TransSECTION Adjustment
ETC Module Learning Procedure
When installing new ETC module or reinstalling it, ETC module learning procedure must be performed.
- Hold the ignition key or the start button at the IG ON position during 5 seconds.
- Turn ignition switch OFF and then start the engine.NOTE: DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.