Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL BASE, AUTOMATIC TRANSREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXMOTOR DRIVEN POWER STEERING SYSTEM DTCS
2015 Kia Soul Base, Automatic Trans
Motor Driven Power Steering System DTCS
2015 Kia Soul Base, Automatic TransSECTION Motor Driven Power Steering System DTCS
MOTOR DRIVEN POWER STEERING SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC C1101 | Battery Voltage High |
| DTC C1102 | Battery Voltage Low |
| DTC C1109 | IGN Signal Error |
| DTC C1112 | Sensor Supply Voltage Error |
| DTC C1259 | Steering Angle Sensor - Electrical Malfunction |
| DTC C1261 | Steering Angle Sensor Not Calibrated |
| DTC C1290 | Torque Sensor Signal Error |
| DTC C1603 | MDPS Thermal Protection |
| DTC C1604 | ECU Hardware Error |
| DTC C1611 | CAN Time-out ECM |
| DTC C1612 | CAN Time-out TCM |
| DTC C1616 | CAN Bus Off |
| DTC C1622 | Vehicle Speed Signal Error |
| DTC C1628 | CAN Time-out Cluster |
| DTC C1646 | CAN Message Failure - TCU |
| DTC C1656 | CAN Signal Error Cluster |
| DTC C1692 | CAN Time-out VSM |
| DTC C1693 | CAN Signal Error VSM |
| DTC C1700 | Byte Coding Error |
| DTC C1702 | Variant Coding Error |
| DTC C1704 | ECU Fail-Safe Relay Fault |
| DTC C1705 | EPS Module (pre-charge circuit) Malfunction |
| DTC C2400 | Motor Fault - Motor Not Running |
| DTC C2401 | Motor Position Sensor Error |
| DTC C2412 | Motor Short or Open |
| DTC C2413 | Motor Current Error |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.