Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SOUL !REPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXTIRE PRESSURE MONITORING SYSTEM DTCS
2015 Kia Soul !
Tire Pressure Monitoring System DTCS
2015 Kia Soul !SECTION Tire Pressure Monitoring System DTCS
TIRE PRESSURE MONITORING SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC C1121 | Sensor 1 Battery Voltage Low |
| DTC C1122 | Sensor 2 Battery Voltage Low |
| DTC C1123 | Sensor 3 Battery Voltage Low |
| DTC C1124 | Sensor 4 Battery Voltage Low |
| DTC C1126 | TPMS ECU Battery Voltage Low |
| DTC C1127 | TPMS ECU Battery Voltage High |
| DTC C1212 | Vehicle Speed Sensor |
| DTC C1312 | Sensor 1 Radio Frequency Channel Failure |
| DTC C1313 | Sensor 2 Radio Frequency Channel Failure |
| DTC C1314 | Sensor 3 Radio Frequency Channel Failure |
| DTC C1315 | Sensor 4 Radio Frequency Channel Failure |
| DTC C1322 | Sensor 1 Over Temperature |
| DTC C1323 | Sensor 2 Over Temperature |
| DTC C1324 | Sensor 3 Over Temperature |
| DTC C1325 | Sensor 4 Over Temperature |
| DTC C1332 | Sensor 1 Fault |
| DTC C1333 | Sensor 2 Fault |
| DTC C1334 | Sensor 3 Fault |
| DTC C1335 | Sensor 4 Fault |
| DTC C1611 | CAN Time-out EMS |
| DTC C1616 | CAN Bus OFF |
| DTC C1660 | Receiver RF Circuit Fail |
| DTC C1662 | Auto Learning failure |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.