Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SEDONA LREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXSMART CRUISE CONTROL SYSTEM DTCS
2015 Kia Sedona L
Smart Cruise Control System DTCS
2015 Kia Sedona LSECTION Smart Cruise Control System DTCS
SMART CRUISE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C110101 | Battery Voltage High |
| C110201 | Battery Voltage Low |
| C120208 | Wheel Speed Sensor Front-LH Invalid/no Signal |
| C120508 | Wheel Speed Sensor Front-RH Invalid/no Signal |
| C120808 | Wheel Speed Sensor Rear-LH Invalid/no Signal |
| C121108 | Wheel Speed Sensor Rear-RH Invalid/no Signal |
| C126008 | Steering Angle Sensor Circuit-Signal |
| C128308 | Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error |
| C136008 | ESP Irreversible Error |
| C160404 | ECU Hardware Error |
| C161108 | CAN Time-out EMS |
| C161208 | CAN Time-out TCU |
| C161608 | C-CAN Bus OFF |
| C161708 | EMS Invalid Engine Speed |
| C162007 | Alignment Failed |
| C162308 | CAN Time-out Steering Angle Sensor |
| C162508 | CAN Time-Out ABS/ESP |
| C162808 | CAN Time-out Cluster |
| C162908 | Cluster Invalid Counter |
| C163208 | Cluster Control Switch Fail |
| C163308 | Cluster Invalid Displayed Speed |
| C163508 | TCS Invalid Counter |
| C163808 | ACC communication error |
| C164208 | CAN Message Failure - Brake |
| C164608 | CAN Message Failure - TCU |
| C174208 | Variant Error - ESC (Check ESC) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.