Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signal Circuit Inspection
2015 Kia Sedona EXSECTION Signal Circuit Inspection
- Connect the Inhibitor switch connector.
- Ignition KEY "ON" & Engine "OFF".
- Measure the voltages between each terminal and chassis ground in each range (P, R, N, D).SIGNAL CODE DESCRIPTION
P P-R R R-N N N-D D Signal "1" 12V 12V 0 0 0 0 0 Signal "2" 0 12V 12V 12V 0 0 0 Signal "3" 0 0 0 12V 12V 12V 0 Signal "4" 0 0 0 0 0 12V 12V
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.