Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE
Smart Cruise Control System DTCS
SMART CRUISE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C110101 | Battery Voltage High |
| C110201 | Battery Voltage Low |
| C120208 | Wheel Speed Sensor Front-LH Invalid/no Signal |
| C120508 | Wheel Speed Sensor Front-RH Invalid/no Signal |
| C120808 | Wheel Speed Sensor Rear-LH Invalid/no Signal |
| C121108 | Wheel Speed Sensor Rear-RH Invalid/no Signal |
| C126008 | Steering Angle Sensor Circuit-Signal |
| C128308 | Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error |
| C136008 | ESP Irreversible Error |
| C160404 | ECU Hardware Error |
| C161108 | CAN Time-out EMS |
| C161208 | CAN Time-out TCU |
| C161608 | C-CAN Bus OFF |
| C161708 | EMS Invalid Engine Speed |
| C162007 | Alignment Failed |
| C162308 | CAN Time-out Steering Angle Sensor |
| C162508 | CAN Time-Out ABS/ESP |
| C162808 | CAN Time-out Cluster |
| C162908 | Cluster Invalid Counter |
| C163208 | Cluster Control Switch Fail |
| C163308 | Cluster Invalid Displayed Speed |
| C163508 | TCS Invalid Counter |
| C163808 | ACC communication error |
| C164208 | CAN Message Failure - Brake |
| C164608 | CAN Message Failure - TCU |
| C174208 | Variant Error - ESC (Check ESC) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
