Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Inspection
2015 Kia Sedona EXSECTION System Inspection
■ Check air leakage
- Visually and physically inspect for air and vacuum leaks in the areas listed below.
- Vacuum hoses for splits, kinks and improper connections.
- Throttle body gasket
- Gasket between intake manifold and cylinder head
- Seals between intake manifold and fuel injectors
- Exhaust system between HO2S and three way catalyst for air leakage
- Have any problems been found?
YES
- Repair as necessary and go to "Verification Of Vehicle Repair " procedure.
NO
- Go to "Check fuel line" procedure.
■ Check fuel line
- Check the fuel line for following conditions
- Damage or leaking fittings and seals
- Bent or restricted fuel line
- Have any problems been found?
YES
- Repair as necessary and go to "Verification Of Vehicle Repair " procedure.
NO
- Go to "Check fuel pressure" procedure.
■ Check fuel pressure
NOTE:
- Gasoline or gasoline vapors are highly flammable/explosive and an empty fuel tank can still contain explosive vapors. A fire could occur if an ignition source is present. When working on fuel system make sure that the work area has adequate ventilation. Do not smoke. Keep sparks and open flames away at all times.
- The fuel system remains under pressure when the engine is not running. Release fuel system pressure before disconnecting any fuel line to reduce the chance of personal injury, or fire damage to vehicle components.
- IG "OFF". Disconnect fuel pump relay in Junction Box.
- Start the engine and wait until it stalls.
- IG "OFF". Connect fuel pump relay.
- Install the fuel pressure gauge to the delivery pipe using the fuel pressure gauge adaptor. (refer to Shop Service Information)
- Activate the fuel pump, check for fuel leaks from the pressure gauge or fuel system.
- Measure the fuel pressure at idle.
Specification: 379.5kPa (3.87kgf/cm2 , 55.0psi)
- Is the measured value within specifications?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace according to the table below. Go to "Verification Of Vehicle Repair " procedure.
Condition Possible Cause Fuel pressure is too low Feul filter, fuel pressure regulator, in-tank fuel hose or in-tank fuel pump Fuel pressure is too high Fuel pressure regulator, hose or pipe
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.