Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015SEDONA EXREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (3 OF 4)DTC INDEX
2015 Kia Sedona EX
DTC Index
2015 Kia Sedona EXSECTION DTC Index
DTC INDEX
| DTC | Description |
|---|---|
| DTC P0351 | Ignition Coil 'A' Primary/Secondary Circuit |
| DTC P0352 | Ignition Coil 'B' Primary/Secondary Circuit |
| DTC P0353 | Ignition Coil 'C' Primary/Secondary Circuit |
| DTC P0354 | Ignition Coil 'D' Primary/Secondary Circuit |
| DTC P0355 | Ignition Coil 'E' Primary/Secondary Circuit |
| DTC P0356 | Ignition Coil 'F' Primary/Secondary Circuit |
| DTC P0365 | Camshaft Position Sensor 'B'(Exhaust) Circuit Malfunction (Bank 1) |
| DTC P0366 | Camshaft Position Sensor 'B'(Exhaust) Circuit Range/Performance (Bank 1) |
| DTC P0391 | Camshaft Position Sensor 'B' Circuit Range/Performance (Bank 2) |
| DTC P0420 | Catalyst System Efficiency Below Threshold (Bank 1) |
| DTC P0430 | Catalyst System Efficiency Below Threshold (Bank 2) |
| DTC P0441 | Evaporative Emission System Incorrect Purge Flow |
| DTC P0442 | Evaporative Emission System-Leak detected (small leak) |
| DTC P0444 | Evaporative Emission System-Purge Control Valve Circuit Open |
| DTC P0445 | Evaporative Emission System-Purge Control Valve Circuit Shorted |
| DTC P0447 | Evaporative Emission System-Vent Control Circuit Open |
| DTC P0448 | Evaporative Emission System - Vent Control Circuit Shorted |
| DTC P0451 | Evaporative Emission System-Pressure Sensor Range/Performance |
| DTC P0452 | Evaporative Emission System-Pressure Sensor Low Input |
| DTC P0453 | Evaporative Emission System-Pressure Sensor High Input |
| DTC P0454 | Evaporative Emission System-Pressure Sensor Intermittent |
| DTC P0455 | Evaporative Emission System-Leak detected (Large leak) |
| DTC P0456 | Evaporative Emission System-Leak detected (Very Small Leak) |
| DTC P0457 | Evaporative Emission System-Leak detected (Tank Cap Loose/Off) |
| DTC P0461 | Fuel Level Sensor 'A' Circuit Range/Performance |
| DTC P0462 | Fuel Level Sensor 'A' Circuit Low Input |
| DTC P0463 | Fuel Level Sensor 'A' Circuit High Input |
| DTC P0464 | Fuel Level Sensor 'A' Circuit Intermittent |
| DTC P0480 | Fan 1 Control Circuit |
| DTC P0504 | Brake Switch 'A'/'B' Correlation |
| DTC P0506 | Idle Air Control System-RPM Lower Than Expected |
| DTC P0507 | Idle Air Control System-RPM Higher Than Expected |
| DTC P050A | Cold Start Idle Air Control System Performance |
| DTC P050B | Cold Start Ignition Timing Performance |
| DTC P0532 | A/C Refrigerant Pressure Sensor 'A' Circuit Low Input |
| DTC P0533 | A/C Refrigerant Pressure Sensor 'A' Circuit High Input |
| DTC P0552 | Power Steering Pressure Sensor/Switch Circuit Low input |
| DTC P0553 | Power Steering Pressure Sensor/Switch Circuit High input |
| DTC P0560 | System Voltage |
| DTC P0562 | System Voltage Low |
| DTC P0563 | System Voltage High |
| DTC P0605 | Internal Control Module Read Only Memory (ROM) Error |
| DTC P0606 | ECM/PCM Processor |
| DTC P0611 | Fuel Injector Control Module Performance |
| DTC P061B | Torque Control Signal Failure |
| DTC P0620 | Alternator Control Circuit |
| DTC P0627 | Trigger-Spill Valve Circuit/Open(EMS-IDM) |
| DTC P0630 | VIN Not Programmed Or Incompatible-ECM/PCM |
| DTC P0641 | Sensor Reference Voltage 'A' Circuit/Open |
| DTC P0651 | Sensor Reference Voltage 'B' Circuit Open |
| DTC P0638 | Throttle Actuator Control Range/Performance |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.