2015 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

[Bank 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Remove the intake manifold.

    (Refer to Engine Mechanical System - "INTAKE MANIFOLD ")

  3. Remove the delivery pipe.

    (Refer to Fuel Delivery System - "DELIVERY PIPE ")

  4. Remove the mounting bolt (A), and then remove the sensor from the cylinder block.
Fig 1: Cylinder Block Sensor Mounting Bolt
G10648876Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Remove the intake manifold.

    (Refer to Engine Mechanical System - "INTAKE MANIFOLD ")

  3. Remove the delivery pipe.

    (Refer to Fuel Delivery System - "DELIVERY PIPE ")

  4. Remove the mounting bolt (A), and then remove the sensor from the cylinder block.
Fig 2: Cylinder Block Sensor Mounting Bolt
G10648877Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.