2015 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

NOTE: Note that the SST (Part No: 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor.

[Bank 1/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 1: Heated Oxygen Sensor Connector (Bank 1/Sensor 1)
    G10648880Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 2: Heated Oxygen Sensor (Bank 1/Sensor 1)
G10648881Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 3: Heated Oxygen Sensor Connector (Bank 1/Sensor 2)
    G10648882Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 4: Heated Oxygen Sensor (Bank 1/Sensor 2)
G10648883Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 5: Heated Oxygen Sensor Connector (Bank 2/Sensor 1)
    G10648884Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 6: Heated Oxygen Sensor (Bank 2/Sensor 1)
G10648885Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
  3. Remove the heated oxygen sensor (B).
Fig 7: Heated Oxygen Sensor And Connector (Bank 2/Sensor 2)
G10648886Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.