Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015RIO LX, 4D HATCHBACK, STANDARD TRANSREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXAUTOMATIC TRANSAXLE SYSTEM DTCS
2015 Kia Rio LX, 4D Hatchback, Standard Trans
Automatic Transaxle System DTCS
2015 Kia Rio LX, 4D Hatchback, Standard TransSECTION Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC P0601 | Internal Control Module Memory Check Sum Error |
| DTC P0705 | Transmission Range Sensor Circuit Malfunction |
| DTC P0706 | Transmission Range Sensor Circuit Range_Performance |
| DTC P0712 | Transmission Fluid Temperature Sensor 'A' Circuit Low Input |
| DTC P0713 | Transmission Fluid Temperature Sensor 'A' Circuit High Input |
| DTC P0717 | Input_Turbine Speed Sensor 'A' Circuit No Signal |
| DTC P0729 | Gear 6 Incorrect Ratio |
| DTC P0722 | Output Speed Sensor Circuit No Signal |
| DTC P0733 | Gear 3 Incorrect Ratio |
| DTC P0734 | Gear 4 Incorrect Ratio |
| DTC P0735 | Gear 5 Incorrect Ratio |
| DTC P0731 | Gear 1 Incorrect Ratio |
| DTC P0732 | Gear 2 Incorrect Ratio |
| DTC P0741 | Torque Converter Clutch Circuit Performance or Stuck Off |
| DTC P0743 | Torque Converter Clutch Circuit Electrical |
| DTC P0748 | Pressure Control Solenoid Valve (VFS) 'A' Electrical |
| DTC P0753 | Shift Control Solenoid Valve 'A' Electrical (UD_B) |
| DTC P0758 | Shift Control Solenoid Valve 'B' Electrical (2-6_B) |
| DTC P0763 | Shift Control Solenoid Valve 'C' Electrical (35R_C) |
| DTC P0768 | Shift Control Solenoid Valve 'D' Electrical (OD_C) |
| DTC P0773 | Shift Control Solenoid Valve 'E' Electrical (SS-A) |
| DTC P0880 | TCM Power Signal Error Open_Short (GND) |
| DTC P0955 | Auto Shift Manual Mode Circuit |
| DTC P1C2B | OPI Hall Sensor Error |
| DTC P1C28 | OPI Current High |
| DTC P2709 | Shift Control Solenoid Valve 'F' Electrical (SS-B) |
| DTC U0001 | High Speed CAN Communication Bus off |
| DTC U0100 | Lost Communication With ECM_PCM 'A' |
| DTC U0287 | Lost Communication With Transmission Fluid Pump Module |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.