SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA SX TURBOREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 107 (ENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.4L (EXCEPT HEV))DTC P0366: CAMSHAFT POSITION SENSOR 'B' CIRCUIT RANGE/PERFORMANCE (BANK 1)SPECIFICATIONSIGNAL WAVEFORM & DATA
2015 Kia Optima SX Turbo

Signal Waveform & Data

2015 Kia Optima SX TurboSECTION Signal Waveform & Data
WARNING: This page is about a different variant/trim than selected.
Fig 1: Signal Waveform Of CKPS & CMPS
G07386589Courtesy of KIA MOTORS AMERICA, INC.
  1. There are 60 signals of CKPS (Including missing tooth) during the semi-cycle of CMPS #2.
  2. There are 3 ~ 5 signals of CKPS between the switching point of CMPS #2 and the missing tooth of CKPS.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.