SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA SX TURBOREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 107 (ENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - 2.4L (EXCEPT HEV))DTC P0336: CRANKSHAFT POSITION SENSOR 'A' CIRCUIT RANGE PERFORMANCEDTC INFORMATIONDTC DETECTING CONDITION
2015 Kia Optima SX Turbo

DTC Information: DTC Detecting Condition

2015 Kia Optima SX TurboSECTION DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION

Item Detecting Condition Possible Cause
DTC Strategy
  • Signal plausibility check
  1. Open or short in signal, ground or power supply circuit
  2. Poor connection or damaged harness
  3. Damage to the connecting flange/flywheel
  4. Misadjusted crankshaft and camshaft pulley position
  5. Faulty CKP sensor
Enable Conditions
  • Engine synchronized
  • Engine speed > 512 RPM
Threshold Value Case 1)
  • Tooth number check (Number of missing/additional teeth > 1)
Case 2)
  • Tooth number check (Number of missing/additional teeth > 2)
Diagnostic Time Case 1)
  • 5 rev.
Case 2)
  • 3 rev.
MIL On Condition
  • 2 Drive Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.