SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015OPTIMA LIMITEDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - 2.0L - OPTIMACAMSHAFT POSITION SENSOR (CMPS)REPAIR PROCEDURESREMOVAL
2015 Kia Optima Limited

Repair Procedures: Removal

2015 Kia Optima LimitedSECTION Removal
CAUTION:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

Bank 1/Intake 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Camshaft Position Sensor Connector & Installation Bolt
    G07379735Courtesy of KIA MOTORS AMERICA, INC.

    Bank 1/Exhaust 

    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
    2. Remove the heater protect cover. Refer to EXHAUST MANIFOLD .
    3. Disconnect the camshaft position sensor connector (A).
    4. Remove the hanger and the protector.
    5. Remove the installation bolt, and then remove the sensor.
    Fig 2: Camshaft Position Sensor Connector
    G07379736Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.