Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSKIA2015OPTIMA LXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 66 (BODY CONTROL MODULE (BCM) - OPTIMA HEV)REPAIR PROCEDURESTROUBLE DIAGNOSTICS WHEN USING GDS

2015 Kia Optima LX

Trouble Diagnostics When Using GDS

2015 Kia Optima LXSECTION Trouble Diagnostics When Using GDS

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Body Control Module

Courtesy of KIA MOTORS AMERICA, INC.

The body control module can diagnose by using the GDS more quickly.
The BCM communicates with the GDS and then reads the input/output value and drives the actuator.
To diagnose the BCM function, select the menu of model and body control module.
To consult the present input/output value of BCM, "Current DATA". It provides information of BCM input/output conditions o power supply, turn signal/brake lamp, headlamp, door, locks, outside mirror, wiper, auto-light and transmitters etc.
- BCM Service data
  
  Fig 2: Display - BCM Current Data Screen
  Courtesy of KIA MOTORS AMERICA, INC.
- CLU (Cluster) Service data
  
  Fig 3: Display - CLU Current Data Screen
  Courtesy of KIA MOTORS AMERICA, INC.
- SJB (Smart junction box) Service data
  
  Fig 4: Display - SJB Current Data Screen
  Courtesy of KIA MOTORS AMERICA, INC.
To perform compulsory operation on BCM input factors, select "ACTUATION TEST".

Fig 5: Display - BCM Actuation Test Screen
Courtesy of KIA MOTORS AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.