Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V8REPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXELECTRONIC STABILITY CONTROL DTCS
2015 Kia K900 V8
Electronic Stability Control DTCS
2015 Kia K900 V8SECTION Electronic Stability Control DTCS
ELECTRONIC STABILITY CONTROL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1101 | Battery Voltage High |
| C1102 | Battery Voltage Low |
| C1112 | Sensor Source Voltage |
| C1200 | Wheel Speed Sensor Front-LH Open/Short |
| C1201 | Wheel Speed Sensor Front-LH Range/Performance/Intermittent |
| C1202 | Wheel Speed Sensor Front-LH Invalid/no Signal |
| C1203 | Wheel Speed Sensor Front-RH Open/Short |
| C1204 | Wheel Speed Sensor Front-RH Range/Performance/ |
| C1205 | Wheel Speed Sensor Front-RH Invalid/no Signal |
| C1206 | Wheel Speed Sensor Rear-LH Open/Short |
| C1207 | Wheel Speed Sensor Rear-LH Range/Performance/ |
| C1208 | Wheel Speed Sensor Rear-LH Invalid/no Signal |
| C1209 | Wheel Speed Sensor Rear-RH Open/Short |
| C1210 | Wheel Speed Sensor Rear-RH Range/Performance/Intermittent |
| C1211 | Wheel Speed Sensor Rear-RH Invalid/no Signal |
| C1235 | Primary Pressure Sensor-Electrical |
| C1237 | Primary Pressure Sensor-Signal |
| C1260 | Steering Angle Sensor Circuit-Signal |
| C1261 | Steering Angle Sensor Not Calibrated |
| C1282 | Yaw Rate & G Sensor-Electrical |
| C1283 | Yaw Rate & G Sensor-Signal |
| C1285 | Longitudinal G Sensor Not Calibrated |
| C1358 | AVH not Available due to EPB in Emergency Release |
| C1503 | TCS/ESC (ESP) Switch Error |
| C1513 | Brake Switch Circuit Error |
| C1604 | ECU Hardware Error |
| C1605 | CAN Hardware Error |
| C1611 | CAN Time-out EMS |
| C1612 | CAN Time-out TCM |
| C1613 | CAN Signal Error ECM (Check ECM) |
| C1616 | CAN Bus OFF |
| C1623 | CAN Time-out Steering Angle Sensor |
| C1628 | CAN Time-out Cluster |
| C1638 | ACC communication error |
| C1647 | CAN Hardware Error - Sensor Channel |
| C1648 | CAN signal error ECM for SCC (Check ECM) |
| C1649 | CAN time-out ECM for SCC (Check ECM) |
| C1650 | CAN signal error SCC |
| C1651 | CAN time-out EPB |
| C1652 | CAN signal error EPB |
| C1656 | CAN Signal Error Cluster |
| C2112 | Valve Relay Error |
| C2130 | Brake Lamp Relay Error |
| C2227 | Excessive Temperature Of Brake Disc |
| C2228 | CAN signal error TCM for SCC (Check TCM) |
| C2380 | ABS/TCS/ESC (ESP) Valve Error |
| C2402 | Motor Electrical |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.