Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSISGENERAL INFORMATIONDTC INDEXSMART CRUISE CONTROL DTCS
2015 Kia K900 V6
Smart Cruise Control DTCS
2015 Kia K900 V6SECTION Smart Cruise Control DTCS
SMART CRUISE CONTROL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1101 | Battery Voltage High |
| C1102 | Battery Voltage Low |
| C1202 | Wheel Speed Sensor Front-LH Invalid no Signal |
| C1205 | Wheel Speed Sensor Front-RH Invalid no Signal |
| C1208 | Wheel Speed Sensor Rear-LH Invalid no Signal |
| C1211 | Wheel Speed Sensor Rear-RH Invalid no Signal |
| C1260 | Steering Angle Sensor Circuit-Signal |
| C1283 | Yaw Rate & Lateral G Sensor-Signal |
| C1360 | ESP Irreversible Error |
| C1604 | ECU Hardware Error |
| C1611 | CAN Time-out EMS |
| C1612 | CAN Time-out TCU |
| C1616 | CAN Bus Off |
| C1617 | EMS Invalid Engine Speed |
| C1620 | ALIGNMENT FAILED |
| C1623 | CAN Timeout Steering Angle Sensor |
| C1625 | CAN Timeout ABS/ESP |
| C1628 | CAN Timeout - Cluster |
| C1629 | Cluster Invalid Counter |
| C1632 | Cluster Control Switch Fail |
| C1633 | Cluster Invalid Displayed Speed |
| C1635 | TCS Invalid Counter |
| C1638 | ACC communication error |
| C1642 | CAN Message Failure - Brake |
| C1646 | CAN Message Failure - TCU |
| C1741 | ESC-not available VSM (Check ESC) |
| C1742 | Variant Error - ESC (Check ESC) |
| C1805 | LKAS CAN Signal Error |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.