Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Removal
2015 Kia K900 V6SECTION Removal
WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative (-) battery terminal.
- Remove the crash pad lower panel after loosening the mounting screws.
(Proceed to Body - "CRASH PAD LOWER PANEL ")
- Disconnect the connector (A) from smart key unit, BCM and tilt & telescopic unit.
- Remove the stop lamp switch of brake pedal.
(Proceed to Brake System - "BRAKE PEDAL ")
- Remove the front smart junction box.
(Proceed to Fuse And Relays - "RELAY BOX (PASSENGER COMPARTMENT) ")
- Remove the smart key (A) and BCM unit (B) after loosening bolt and nuts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.