Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Power Window Switch Inspection
2015 Kia Forte EXSECTION Rear Power Window Switch Inspection
- Disconnect the negative (-) battery terminal.
- Remove the rear door trim panel.
(Refer to "REAR DOOR TRIM ")
- Disconnect the 8P connector from the switch.
- Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
- Remove the power window switch (A) after loosening the screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.