Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015CADENZA PREMIUMREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEMVARIABLE INTAKE SOLENOID (VIS) VALVEREPAIR PROCEDURESREMOVAL
2015 Kia Cadenza Premium
Repair Procedures: Removal
2015 Kia Cadenza PremiumSECTION Removal
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Disconnect the variable intake solenoid valve connector (A).
- Disconnect the vacuum hoses (B, C) from the valve.
- Remove the installation nut (D), and then remove the valve.
[Valve 1 (Intake manifold)]
Courtesy of KIA MOTORS AMERICA, INC.
[Valve 2 (Surge tank)]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.