2015 Kia Cadenza LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Using a screw driver or remover, remove the center fascia lower panel (A).
    Fig 1: Identifying Center Fascia Lower Panel
    G09753128Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit.
    Fig 2: Identifying In-Car Hose Connectors
    G09753129Courtesy of KIA MOTORS AMERICA, INC.
  4. Using a screw driver or remover, remove the crash pad garnish [RH] (A).
    Fig 3: Identifying Crash Pad Garnish (RH)
    G09753130Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the AVN head unit (A) after loosening the mounting screws.
    Fig 4: Identifying AVN Head Unit
    G09753131Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the connectors (A) from the AVN head unit.
    Fig 5: Identifying AVN Head Unit Connectors
    G09753132Courtesy of KIA MOTORS AMERICA, INC.
  7. Using a screw driver or remover, remove the crash pad side cover (A).
    Fig 6: Identifying Crash Pad Side Cover
    G09753133Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the crash pad lower panel (A) after loosening the mounting screws.
    Fig 7: Identifying Crash Pad Lower Panel
    G09753134Courtesy of KIA MOTORS AMERICA, INC.
  9. Disconnect the connectors (A).
    Fig 8: Identifying Crash Pad Lower Panel Connectors
    G09753135Courtesy of KIA MOTORS AMERICA, INC.
  10. Remove the crash pad center panel (A) after loosening the mounting screws.
    Fig 9: Identifying Crash Pad Center Panel
    G09753136Courtesy of KIA MOTORS AMERICA, INC.
  11. Remove the ignition key grommet (A) after loosening the mounting screws.
    Fig 10: Identifying Ignition Key Grommet
    G09753137Courtesy of KIA MOTORS AMERICA, INC.
  12. Disconnect the start/stop button connector (A).
    Fig 11: Identifying Start/Stop Button Connector
    G09753138Courtesy of KIA MOTORS AMERICA, INC.
  13. Remove the start/stop button (A) by pushing the both sides of the hooks.
    Fig 12: Removing Start/Stop Button
    G09799612Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.