Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2014 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Output Speed Sensor: Specification

ITEM SPECIFICATION

Item	Specification
Type	Hall Effect Sensor, 2 pins (Power: 9V, Signal)
Operation condition	-40 ~ 150 (°C) (-40 ~ 302 (°F))
Sensor length	30.7 ~ 30.9 mm (1.2087 ~ 1.2165 in.)
Air gap	1 ~ 0.55 mm (0.0394 ~ 0.0217 in.)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.