2013 Kia Optima SXFACTORY OEM SERVICE PROCEDURE

Heated Oxygen Sensor (HO2S): Specification

HO2S (Bank 1/Sensor 1) 

ITEM SPECIFICATION CHART

Item Specification
Heater Resistance (Ω) 2.5 ~ 4.0 (20°C (68°F))

HO2S (Bank 1/Sensor 2) 

VOLTAGE SPECIFICATION CHART

A/F Ratio (λ) Output Voltage (V)
RICH Approx. 0.9
LEAN Approx. 0.04
ITEM SPECIFICATION CHART

Item Specification
Heater Resistance (Ω) 3.3 ~ 4.1Ω(21°C (69.8°F))
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.