Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Kia Soul !FACTORY OEM SERVICE PROCEDURE

Repair procedures: Replacement

Remove the floor console assembly.
(Refer to "CONSOLE ".)
Loosen the mounting nut (A) and then remove the shift lock cable from the shift lock cam (B).
Tightening torque:

9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

Fig 1: Identifying Shift Lock Cam And Mounting Nut
Courtesy of KIA MOTORS AMERICA, INC.
Remove the snap pin (B) and shift lock cable (C) from the brake pedal assembly (A).

Fig 2: Identifying Brake Pedal Assembly, Shift Lock Cable And Snap Pin
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE: Adjust the shift lock cable after installing.
(Refer to "SHIFT LOCK CABLE (ADJUST) " in this group)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.