Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Kia Soul !FACTORY OEM SERVICE PROCEDURE
Monitor GDS Data
- Ignition ON & Engine OFF.
- Connect GDS to Data Link Connector(DLC).
- Select "Diagnostic Trouble Codes(DTCs)" mode and monitor "DTC Status" parameter.
- Clear recorded DTC using GDS.
- Ignition switch OFF ↔ Ignition switch ON 2~3 times and Selet "Diagnostic Trouble Codes(DTCs)" mode and monitor "DTC Status" parameter.
- Is the DTC present?
YES
- PCM's ROM or DATA is changed by reprogram illegally.
- Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault is intermittent caused by poor contact of PCM and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
