2012 Kia Optima SXFACTORY OEM SERVICE PROCEDURE

Front Wiper Intermittent Control

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
  • In case of IGN2 On (L_IGN2 = ON), if turn on the Wiper Intermittent Switch (L_WiperIntmtswitch= On), then Wiper Low output is turned on depending on Wiper Intermittent Time (WiperIntmtTime, this value is defined by A_WiperIntmtVol input value).
Fig 1: Front Wiper Intermittent Timing Pattern
G07426823Courtesy of KIA MOTORS AMERICA, INC.

T1: One wiping, T2: Wiper intmt time

VALUE SPECIFICATION CHART

Value Name Value
One Wiping 0.7 sec Β± 70 msec
Con Wipe Time 2 sec
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.