Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Kia Forte LX, Automatic TransFACTORY OEM SERVICE PROCEDURE
Lamp Control
- Exterior Lamp Control Data Flow
- Tail Lamp Auto Cut
- Turn IGN KEY OFF when turning Tail switch ON after turning IGN KEY ON and turn Tail Lamp Relay OFF (automatic blackout) when opening Driver door switch.
- Also, turn Tail Lamp Relay OFF (automatic blackout) even though IGN KEY is turned OFF after opening Driver door switch at the condition that IGN KEY is ON.
- When turning Tail switch ON again from OFF after the automatic blackout, Tail Lamp Relay will be turned ON and AUTO CUT function will be cancelled.
- When turning IGN KEY ON after the automatic blackout, Tail Lamp Relay will be turned ON and AUTO CUT function will be cancelled.
- AUTO CUT will be kept when removing or installing B+ at the status of AUTO CUT.
- Tail Lamp Relay will be kept turning OFF though Driver door switch is closed from opened at the status of AUTO CUT.
*1 IGN ON : KEY IN ON or ACC ON or IGN1 ON or IGN2 ON (NON SMK)
SSB switch ON or FOB IN ON or ACC ON or IGN1 ON or IGN2 ON (SMK)
- Head Lamp Low
- Turn Head Lamp Relay ON when turning Head Lamp switch ON while IGN1 is ON.
- Turn Head Lamp Relay OFF if IGN1 OFF or Head Lamp switch is OFF.
- Do not control things above if Head Lamp Relay can be controlled by Auto Light function.
- Front Fog Lamp
- Turn Front fog relay ON when turning Head lamp high switch OFF while IGN2 and Head lamp relay ON.
- Turn Front fog relay OFF when turning Front fog switch OFF while Front fog relay ON.
- Turn Front fog relay OFF when turning IGN2 OFF while Front fog relay ON.
- Turn Front fog relay OFF when turning Head lamp high switch ON while Front fog relay ON.
At this time, turn the front fog relay ON when Head lamp switch OFF.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
