Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Kia Forte L4-2.0LFACTORY OEM SERVICE PROCEDURE
Power Window Switch: Testing and Inspection
Inspection
Power Window Main Switch Inspection
1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim.
3. Disconnect the connector from the switch and remove the screws.
CAUTION:
Be careful not to damage the hooks when removing the switch module.
4. Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
(A : Auto Down, B : Auto Up & Down)
Passenger Power Window Switch Inspection
1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim.
3. Remove the power window switch module(A).
4. Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
(A : Door Lock / Unlock, B : General)
Rear Power Window Switch Inspection
1. Disconnect the negative (-) battery terminal.
2. Remove the rear door trim.
3. Remove the rear power window switch module.
4. Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.