Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Kia Forte L4-2.0LFACTORY OEM SERVICE PROCEDURE
Flex Plate
Flex Plate
Install the drive plate (AT only)
Tightening torque 117.7 - 127.5 N.m (12 - 13 kgf.m, 86.8 - 94.0 lb-ft)
NOTE:
- Always use new flywheel (drive plate) bolts(C).
- Apply sealant to the screw part (8mm from the end of the bolt) when using new flywheel bolts.
Sealant:Three bond 2403, Loctite 200 or 204
- Install and uniformly tighten the 7 bolts, in several passes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.