2011 Kia Soul BaseFACTORY OEM SERVICE PROCEDURE

Description and Operation: Description

The Heated Oxygen Sensors (HO2S) consists of zirconium and alumina, and are installed both upstream and downstream of the Manifold Catalytic Converter (MCC).

The sensor looks at the difference between the oxygen in the atmosphere with the oxygen in the exhaust gas. The greater the difference in oxygen, the higher the voltage produced by the sensor. When A/F ratio is rich it generates approximately +1V and when the A/F ration is lean it is near 0V.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Fig 1: Identifying Heated Oxygen Sensor Components
G06526169Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.