Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Kia Rondo (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE
Heater Control Unit Replacement
REPLACEMENT
HEATER CONTROL UNIT REPLACEMENT
1. Remove the center facia panel.
2. After loosening the heater control mounting screws,remove the heater control unit (A).
3. Installation is the reverse of removal.
NOTE:
Make sure the connector is plugged in properly
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.