2011 Kia Rio LXFACTORY OEM SERVICE PROCEDURE

Repair procedures (A4AF3): Disassembly

  1. Remove the push button (A) from the knob sub assembly.
    Fig 1: Identifying Push Button
    G06828968Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove the knob sub assembly from the lever sub assembly. (Screw:1EA)
    Fig 2: Identifying Lever Sub Assembly Screw
    G06828969Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the indicator assembly (A).
    Fig 3: Identifying Indicator Assembly
    G06828970Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the detent spring (A). (Bolt:1EA)
    Fig 4: Identifying Detent Spring
    G06828971Courtesy of KIA MOTORS AMERICA, INC.
  5. Loosen the bracket sub assembly nut (A).
    Fig 5: Identifying Bracket Sub Assembly Nut
    G06828972Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the screw.
    Fig 6: Identifying Bracket Sub Assembly Screw
    G06828973Courtesy of KIA MOTORS AMERICA, INC.
  7. Disassemble the bracket sub assembly (A) after removing the cotter pin (2EA).
    Fig 7: Identifying Bracket Sub Assembly
    G06828974Courtesy of KIA MOTORS AMERICA, INC.
  8. Disassemble the hinge shaft from the lever sub assembly.
    Fig 8: Identifying Hinge Shaft And Lever Sub Assembly
    G06828975Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.