2011 Kia Rio L4-1.6LFACTORY OEM SERVICE PROCEDURE

Cruise Control Switch: Service and Repair





Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the driver airbag module.
3. Remove the steering wheel.
4. Remove the steering wheel cover after loosening the 4 screws.

Factory service manual diagram



5. Remove the hands free remote control switch(A) after removing the steering wheel remote control switch connector(B) and 2 screws.

Factory service manual diagram




Factory service manual diagram



6. Installation is reverse order of removal.

Inspection

Measuring Resistance
1. Disconnect the cruise control switch connector from the control switch.

Factory service manual diagram



2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).

Factory service manual diagram




3. If not within specification, replace switch.

Measuring Voltage
1. Connect the cruise control switch connector to the control switch.

Factory service manual diagram



2. Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).

Factory service manual diagram




3. If not within specification, replace switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.