2011 Kia Rio BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Disassembly

  1. Remove the generator cover (A) using a screw driver (B).
    Fig 1: Removing Generator Cover Using Screw Driver
    G06828687Courtesy of KIA MOTORS AMERICA, INC.
  2. Loosen the mounting bolts (A) and disconnect the brush holder assembly (B).
    Fig 2: Identifying Brush Holder Assembly With Mounting Bolts
    G06828688Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the slip ring guide (A).
    Fig 3: Identifying Slip Ring Guide
    G06828689Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the nut, pulley (A) and spacer.
    Fig 4: Removing Nut, Pulley And Spacer
    G06828690Courtesy of KIA MOTORS AMERICA, INC.
  5. Loosen the 4 through bolts (A).
    Fig 5: Identifying Through Bolts
    G06828691Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the rotor (A) and cover (B).
    Fig 6: Identifying Rotor And Cover
    G06828692Courtesy of KIA MOTORS AMERICA, INC.
  7. Reassembly is the reverse of disassembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.