Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Kia Sedona BaseFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODES DTC (LIST)
| DTC | Description |
|---|---|
| DTC P0707 | Transaxle Range Switch Circuit Low Input |
| DTC P0708 | Transaxle Range Switch Circuit High Input |
| DTC P0711 | Transaxle Fluid Temperature Sensor Rationality |
| DTC P0712 | Transaxle Fluid Temperature Sensor Circuit Low Input |
| DTC P0713 | Transaxle Fluid Temperature Sensor Circuit High Input |
| DTC P0717 | AT Input Speed Sensor Circuit-Openor Short(GND) |
| DTC P0722 | AT Output Speed Sensor Circuit-Openor Short(GND) |
| DTC P0731 | Gear 1 Incorrect Ratio |
| DTC P0732 | Gear 2 Incorrect Ratio |
| DTC P0733 | Gear 3 Incorrect Ratio |
| DTC P0734 | Gear 4 Incorrect Ratio |
| DTC P0735 | Gear 5 Incorrect Ratio |
| DTC P0741 | Torque Converter Clutch Stuck Off |
| DTC P0742 | Torque Converter Clutch Stuck On |
| DTC P0743 | Torque Converter Clutch Control Solenoid Valve-Openor Short(GND) |
| DTC P0746 | VFS Solenoid Valve Malfunction |
| DTC P0748 | VFS Solenoid Valve Circuit-Openor Short(GND) |
| DTC P0750 | Lowand Reverse Solenoid Valve Circuit-Openor Short(GND) |
| DTC P0755 | Underdrive Solenoid Valve Circuit-Openor Short(GND) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
