Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Kia Forte EX, AutomaticFACTORY OEM SERVICE PROCEDURE
Repair procedures: Removal
CAUTION:
- Removal of the airbag must be performed according to the precautions/procedures (Refer to AIRBAG MODULE (RESTRAINTS - ADVANCED) ).
- Before disconnecting the front impact sensor connector, disconnect the front airbag connector (s).
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
- Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
- Disconnect the Front Impact Sensor connector.
- Remove the Front Impact Sensor mounting bolt.
- Remove the Front Impact Sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.