Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Control Module: Service and Repair
2009 Kia Sorento 2WD V6-3.3LSECTION Service and Repair
REPLACEMENT
1. Turn ignition switch off.
2. Disconnect the battery (-) cable from the battery.
3. Remove the resonator (A).
4. Disconnect the ECM connectors (A).
5. Unscrew the ECM mounting bolts (B) and remove the ECM from the bracket (C).
6. Install new ECM
ECM installation bolts : 9.8 - 11.8 Nm (1.0 - 1.2 kgf-m, 7.2 - 8.7 lbf-ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.