2009 Kia Sedona BaseFACTORY OEM SERVICE PROCEDURE

Driver/Assist Door Module (DDM/ADM)

  1. Remove (-) negative battery terminal.
  2. Remove the front door trim panel. Refer to FRONT DOOR .
  3. Disconnect the door module mounting screws (5EA) after disconnecting the module connectors (3EA) from the motor.
    Fig 1: Identifying Door Module And Mounting Screws
    G04884951Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the door module (DDM/ADM) (A) from the front door trim panel.
    Fig 2: Identifying Front Door Modules
    G04884952Courtesy of KIA MOTORS AMERICA, INC.
  5. Installation is the reverse of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.