2009 Kia Optima EX, 2.4 3FACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (Pcm): Replacement

  1. Turn ignition switch off.
  2. Disconnect the battery (-) cable from the battery.
  3. Remove the PCM cover and disconnect the PCM connector(s) (A).
    Fig 1: Identifying PCM Cover And PCM Connector
    G06361925Courtesy of KIA MOTORS AMERICA, INC.
  4. Unscrew the PCM mounting bolts (B) and remove the PCM (C) from the air cleaner assembly.
    Fig 2: Identifying PCM Mounting Bolts And PCM
    G06361926Courtesy of KIA MOTORS AMERICA, INC.
  5. Install a new PCM.

    PCM mounting bolts:Β  9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 lb-ft)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.