2009 Kia Optima EX, 2.4 3FACTORY OEM SERVICE PROCEDURE

VIN Programming Procedure

VIN (Vehicle Identification Number) is a number that has the vehicle's information (Maker, Vehicle Type, Vehicle Line/Series, Body Type, Engine Type, Transmission Type, Model Year, Plant Location and so forth. When replacing an PCM, the VIN must be programmed in the PCM. If there is no VIN in PCM memory, the fault code (DTC P0630) is set.

CAUTION: The programmed VIN cannot be changed. When writing the VIN, confirm the VIN carefully
  1. Select "Vehicle" and "Engine" (For example, SEDONA 3.5L V6).
    Fig 1: Scan Tool Display - SEDONA
    G06361920Courtesy of KIA MOTORS AMERICA, INC.
  2. Select "VIN WRITING".
    Fig 2: Scan Tool Display - VIN WRITING
    G06361921Courtesy of KIA MOTORS AMERICA, INC.
  3. Check the PCM status.
    Fig 3: Scan Tool Display - PCM Status
    G06361922Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.