Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Kia Borrego LX, 3.8 1, RWDFACTORY OEM SERVICE PROCEDURE
Repair procedures: Removal
NOTE:
In the case of the vehicle equipped with immobilizer, perform
Key Teaching procedure. (Refer to
TEACHING PROCEDURES
).
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the ECM connector (A) after removing the connector fixing clip (B).
- After removing the installation bolts (A), remove the ECM (B) from the bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.