2008 Kia Sedona BaseFACTORY OEM SERVICE PROCEDURE

Starter Test Procedure: Notes

  1. After the battery test, press ENTER immediately for the starter test.
    Fig 1: Identifying Micro 570 Analyzer Display - ENTER
    G04803973Courtesy of KIA MOTORS AMERICA, INC.
  2. After pressing ENTER key, start the engine.
    Fig 2: Identifying Micro 570 Analyzer Display - START ENGINE
    G04803974Courtesy of KIA MOTORS AMERICA, INC.
  3. Cranking voltage and starter test results will be displayed on the screen.

    Take a relevant action according to the test results by referring to the starter test results as given below.

    Fig 3: Identifying Micro 570 Analyzer Display - CRANKING VOLTAGE NORMAL
    G04803975Courtesy of KIA MOTORS AMERICA, INC.
  4. To continue charging system test, press ENTER.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.