Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Kia Rondo V6-2.7LFACTORY OEM SERVICE PROCEDURE
Connecting Rod
Connecting Rod
Specification
Standard 0.1 - 0.25 mm(0.0039 - 0.0098 in.)
Limit 0.4 mm(0.0157 in.)
Tightening torque 19.6 Nm (2.0 kgf.m, 14.46 lb-ft) + 90°
Standard oil clearance 0.018 - 0.036 mm(0.0007 - 0.0014 in.)
Bending 0.05 mm/100 mm(0.0020 in./3.9370 in.)
Torsion 0.1 mm/100 mm(0.0039 in./3.9370 in.)
Piston pin-to-connecting rod interference -0.033 ~ -0.016 mm (-0.0013 ~ -0.0006 in.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.